Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between circuit and network.
- 15 Answers
- 70803 Views
- Jadavpur University, Sail, TCS, I also Faced
- E-Mail Answers
Answer Posted / vishvesh
when more than one power sources are connected in the
circuit at different sides of the circuit then it becomes
network.
| Is This Answer Correct ? | 24 Yes | 91 No |
Post New Answer View All Answers
what is the voltage rating of chiller unit sensors
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
What are the different types of dams?
What is Instantaneous Earth fault relay,how will work
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
Installation method of self treated earth electrode.
Explain what is electric traction?
How to discuss the phase shift of transformer considering open delta?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
Can clean earth cable be considered as low current cable
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
What Normal(Tangent) towers and Tension(Cut-point) Towers?
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
how does it help for selection of a transformer.
hello if any one have papers vof hpcl or sail, plz send me
