Why Power generation in India is at 50Hz while in America
its 60Hz so is there any advantage/Disadvantage of this ??
Answer Posted / vishvesh
well, for the safety reason of the consumer in the US, they
decided to kept voltage level at 110V a.c. at the consumer
end. but to avoid distribution loss and over heating of the
conductors they kept frequency of AC supply at 60 Hz. to
reduce that losses.
Is This Answer Correct ? | 2 Yes | 11 No |
Post New Answer View All Answers
Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?
How to see the inductance in a transmission lines
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
If increased the frequency up to 1000 then what changes shows in voltage?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
What was your role in the silicon evaluation/product ramp? What tools did you use?
explain safety measures in alternator?
What are the protections for safe running of electric generator?
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
what is the function of bearing in dc mchine" and where it is placed
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
why industry prefer ht motor instead of lt motor.
Is neutral transformer can be called as control transformer?