Answer Posted / harish bhise
1 occupy max. component in min.area
2 to avoid emi
3 get the refrence point for gnd.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
when a magnet is heated?
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
What are the types of valves?
What is the principle of capacitance type level transmitter?
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
State bernoulli’s application.
How u measure the massflow in orifice flow measurement techniques
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
How flow can be measured with dp?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
Which products are available in the Mass Systemswitch and System Manager AC range?
