I have draw the 350A DC current, so what is the size of
cable i can use? Give me the answer with formula
- 1 Answers
- 3732 Views
- I also Faced
- E-Mail Answers
Answer Posted / thowsif_emerson_csm team
Pls Provide me the following details:-
1. Rated Current.
2. Capacity of Protective Circuit Breaker used.
3. Total Length of cable.
4. Total voltage drop.
5. Laying Method.i.e. underground,in conduit,in trays etc.
6 No. of cables.i.e. grouping factor.
7. Ambient Temperature of installed area.
Temperature Correction Factor to be applied.
8. Type of cable. i.e. singel core,multicore,PVC insulated,
Armoured, XLPE insulated etc.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What happen if 200 KVAR capacitor connected to power continuesly?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
Electrical Engineering
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
What is the effect of positive feedback on the stability of the systems?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is different bewteen low or high impedance busbar protection scheme
What is the difference between vector surge relay (78) and Pole slip relay (98G)
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
What happens if the series current double?
What is the exact formula for one weber of magnetic flux?
