Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / thowsif_emerson_csm team
The number of cycles per unit of time is called the
frequency. For convenience, frequency is most often
measured in cycles per second (cps) or the interchangeable
Hertz (Hz)...
| Is This Answer Correct ? | 34 Yes | 4 No |
Post New Answer View All Answers
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
why output is out of phase in case of common emitter?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
Difference between low impedance and high impedance Restricted Earth Fault
What is different between Difnit time and instatous over current relay
What is the difference between electrical earthing and electrical grounding?
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
block diagram of 2 ups system connected in parallel mode?
what is interfacing in computer studies?
Is Transol transformer oil comparable to nynas nytro libra?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
Define open loop control system.
what percent do you derate your copper wire when you change from copper buss to copper wire
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
