why do we generate only 3ph ac?is it possible to generate
4ph,5ph,....?
- 6 Answers
- 14055 Views
- Accenture, Bhel, Reliance, I also Faced
- E-Mail Answers
Answer Posted / dhiren
mostly we use 1ph and 3ph and 6ph , 3ph line we can use it
as a 1ph or 3ph and also as a 6ph . so as per requirement
mostly generation is been done 3ph .
yes , generation of any phase can be done but we generate
which we required.
3ph is suitable for all so ....
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
What are the differences between single phase and three phase?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
what is kvarh? Please define it With calculation General motors ?
what is cathodic protection and why it use in industries?
what is meant by surge? what we called for high currents?
what is d check in dg 1500kva
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
Why squirrel cage motor can only use with low starting loads ?
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
How would you relate your key competencies to this position?
Why GRR starts from 60% of motor speed why not less than 60%?
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
How to select a cable size for particular load?
