In footing (mat) if two different dia of rods are to be used
which rod should be placed at top and bottom ( eg. 10mm &
16mm dia rods)
Answer Posted / jambu
Always bigger dia should be laid at bottom and it should be
provided on shorter directions.
Is This Answer Correct ? | 61 Yes | 1 No |
Post New Answer View All Answers
How much cement and sand are required for 1 square feet of plaster at a thickness of 15 mm at a ratio of 1:4?
usually hand broken stones are used for cement concrete 1:4:8 in foundation of single /two story houses with a view of economy in construction.what advantages it will give if you use machine crushed stone in place?
For what purpose bedding is used under storm water drains, explain?
How to marking the building
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
How is the strength of cement measured?
How many Rod required for 58 feet by 24 feet roof slab which is supported by 5 * 3 = 15 Column. Six Stored building Roof Slab = ? Ton 15 Column = ? Ton Slab Beam = ? Ton
how can we calculate steel value, depending on load
how do you calaculate the total steel quantity of an rcc building using thumb rule?
what is the construction cost for per cft of multistorryed building in kolkata?
Minimum concrete cover in slabs, columns, beams, foundation and other st?
what could be the production cost of 1 cum of concrete by CP30 plant
Discuss some applications of modular elasticity?
What is the difference between yeild strength and compressive strength of steel???
If u want ur Ans.Of any Question so mail me skatiyar011@yahoo.in