Answer Posted / lee naidoo
it is system that controls instruments in the plant,
however there are several controleers that are distributed
tthroughout the plant, hence Distributed control systems
(DCS).example one controller controlls the filling of
bottles with milk, another controller controls how the
bottles get packed in a crate, etc.however all these
controllers are networked and share information.
| Is This Answer Correct ? | 13 Yes | 4 No |
Post New Answer View All Answers
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
Do you have reference list?
Explain the mechanism behind the turbine meter.
how do u calibrate the vacuum transmitter if it shows more reading
how to check earthing,what is minum ohms for proper earthing
What are different types of valves?
Capacitance, resistance ( colour coding ), parallel & series circuits.
what does it mean an active front end in vfd plz explain it briefly
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
In turbine what does term CDP, NI, NH, HSSOC means.
line up procedure for dp type flow transmitter?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
