Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajkumar
PCBs ---solid electronics and occupies lesser space ,
consumes lesser power,low cost spares etc...
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
what is the diffrence between pressure safety valve & pressure relief valve....pls
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
how to calibrate load cell
Describe the function of Accumulator into the Pump
How to Calibrate Vibration Probe (Axial, Redial) in field
how to calculate control valve bonnet size?? or how to select its material?
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
How the sizing of the analog signal cable is calculate?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
i am having information technology branh ....... can i prepare for psu exam
