Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / amit yadav
where orifice plate is used to measure flow alone, the
signal is square rooted. it is by the formula Q=K square
root of Differential pressure.
when magnetic flow meter is used flow is linear
emf= v*B*L
V=VELOCITY OF FLOW
b=magnetic field
l=diameter of pipe
| Is This Answer Correct ? | 19 Yes | 8 No |
Post New Answer View All Answers
What is the difference between ff transmitter and non ff transmitter
Explain an adaptive / self-tuning controller’s major draw card.
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Explain why plc require in analog input 4-20amp & 0-10 volt?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
how many type conductivity sensor ?
List three types Level Switches with their working principles
Give 2 application of quartz crystal used for process parameter measurement.
what is performance test.need defination
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
