Answer Posted / arshad
the branch in which we study the forces applied on the
body, production process , properties of material's &
design process.
Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
Draw a crankshaft and show the parts?
difference between machining and non-machining?
In Rankine Cycle we use the concept of Tm(mean temperature of heat addition).In actual cycle the efficiency comes as n=1-T2/T1 Taking Tm into consideration it comes as n=1-T2/Tm as T1>Tm so the efficiency for both case will not same for a same cycle. Can anybody explain how it is possible? Advance appreciation for your effort.Thanks
At 50 Centigrade (Fuel oil) what is its cast?
what should be sensor sensitivity of accelerometer in vibration? And what is the main difference between accelerometer and proximity sensors and others?
Sir we wants to const ruct a wall,size wall is 50x30x9/12' feet.how many bricks required. Please advise
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
What is the name of solid solution of carbon in alpha iron and delta iron ?
what is lube oil cons./hours in diesel engine ???
What is the use of gravity disc?
Explain the hooke`s coupling.
i am from karnataka can i able to apply appsc
How does the steam work in a steam turbine?
What is IS standard in case of mode of measurement for ducting
What is the b check value of a 4bt engine