Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tukoweke
The relay serves to detect a fault in a transfomer that is
leading to the decomposition and accumulation of gas in the
tx or leakage of oil thus lowering the oil level, by making
contacts in the float and sending an alarm signal.
In case the fault persists and the gas accumulation
increases or when an arc takes place in the tx windings,
the oil surges up into the conservator tank and makes
contacts in the float/vane to send a message to the trip
coil of the breaker, thus isolating the transformer from
further damage by the fault.
| Is This Answer Correct ? | 14 Yes | 5 No |
Post New Answer View All Answers
How wire size can define in electrical wiring? What is the ratio?
WHAT IS LOAD CELL
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
I Have 3 Phase 10 KW AC Alternator i found one phase weak, so what will be the reason & what action shouls i take to rectify the same.
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
c++ write a program to use a fuction call "max"which accepts an intger arrey of size5.as an arrument and return the larger and smallest of the arrey to main without changing. the original changing of the original position of the element of the arrey.
what will happen when the dc supply is given to the capacitor?
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
what is current check gurd relay?
What is the lower limit of break-down voltage of converter transformer.
can any tell me why slope 40% and 80% is calculated in differential protection?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
