Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sateesh
It is a energy stored element and it opposes the sudden
changes of current
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
where lt & ht capacitor used
When lag/lead/lag-lead compensation is employed?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
cc of scorpio?
Is any generator is developed which is operated with out diesal or other expensive source?
List some examples of renewable energy?
what is the difference between fault current ant short circuit current?
what is the current setting for different relay protection for transformer .
What are the types of windings according to the construction?
What is Bolted fault?
What is the basic of DTH.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
I want to merge a cable..in between two metering Cubicals which contains CT's and PT's and Energy meter..before taking merger..what are the common things required?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
