Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / poomalai
the need high rotating speed.so we are using universalmotors
for the high speed operation.
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
block diagram of 2 ups system connected in hot stand by mode?
What's mean HVF & HAF in Vacuum Circuit Breaker?
how to calculate fault level?
What is the settings of distance protection relay in 400 kv line
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to calculate fuse rating for a motor
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
where we use the SFU & FSU?
How to calculate fault level of 11 KV system
How much of the total hydro power potential has been exploited so far in india?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
how withstand of hi-pot test outputs of transformer wire 2.5mm
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
State and define norton’s theorem?
