Answer Posted / sathis.b
we control the valve thru the positioner for the require
percentage we need.
for ex: if u want to open the valve 25%, the command give
from control room it will open or close thru' the
positioner also the forward or reverese of the valve
direction.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
Explain how thw analog to digital converter works with the circuit diagram
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
NSV type probe stands for
why we are using magnet for calibration of gas detector?
in differential pressure transmitter,min&max pressure range for hp&lp
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
for oil & gas industries which zone is normally preferred? why? give its example?
How to calibrate smoke Dectector
What is stripper & spilitter ? Diffrence in this.?
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
how to calibrate corollaries (Mass flow meter)?
If P will increase then what will happen with PID?
Which type of pressure can be measured by primary elements?
