Answer Posted / ulaganathan
thro LDA command the input is m,ade tostore in the
accumulator , these is stored in the form of BCD.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
diff between neutral ,ground,phase , earthing and shielding?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
What is the principle of capacitance type level transmitter?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
what is a half wave, full wave, and bridge rectifer.
What is difference between differential pressure & delta pressure?
what is the process to make control schematic ?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
What are advantages and disadvantage of the ac supply load cell?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
How many ohms are required for proper earthing?
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.