Answer Posted / guest
Residual current circuit breaker trips or give protction
against minor fault or leakage than MCCB.
Is This Answer Correct ? | 12 Yes | 9 No |
Post New Answer View All Answers
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
what is difference between 2 pole structure and 4 pole structure in transformer yard
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
How to decide DO set rating of Transformer?
How to select a transformer group to connect a 0,433 KV generation with 33 KV grid in bi directional flow of current
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
what is the cause of voltage dipp or swell in the transmission lines?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
Mention the difference between Analogue and Digital circuit?
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
What is control system?
What are the different methodes for calculating the short circuit Current?
How test for Ddo vector group test condition?