Interested to Buy Any Domain ? << Click Here >> for more details...
A solid body of weight W is placed in a pipe. Suppose
water is started flowing through the pipe.what will happen
to the body. when it will start flowing ?
- 11 Answers
- 15063 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / ananth
The body is in a state of rest. There is friction between
the body and the pipe wall. The force of friction is the
product of the body's weight (not mass) and the friction
coefficient. This friction force resists any motion and
acts against the esternal force. If the water flows with
sufficient velocity, there can be Let the mass of water
coming in contact with the stone be Mw. Assuming it comes
to total stop on hitting the stone, the momentum transfer
to the body from the water will enable the body's movement.
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
Explain the causes of the exhaust valve leakage.
How hydrulic power stearin @ lutch works plz explain?
Which are the sheets of metals?
How would you increase the volume efficiency of centrifugal pump?
Hello friends on 10th feb my campus interview of Vikram Cement group compony of Aditya Birla.So please suggest me which kind of prepration I have done to success the interview.
What is the common source of leak in stern tube
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
Why must we pay attention when we drain steam in steam turbine. What factors are observed?
Please tell about the water type h.v.a.c with it's cycle and functions of each parts ?show me how talented u r?
on which basis safety valves are set with particular pressures?
Classification of bunkers?
What is gtsc technology?
What are the causes of liner high temperature?
What do you know about DG ,A,B,C, D, Check and safety of generator.?
