Interested to Buy Any Domain ? << Click Here >> for more details...
In a house wiring why we are using only one neutral wire and
so many phase wires from the main board, when the load is
common for both wires?
- 3 Answers
- 16902 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajayan
Mr Karthik,In the 3 Ph system also we are having one
neutral wire.Neutral wire is the return path for all the
phases even it is single phase or three phase.
| Is This Answer Correct ? | 19 Yes | 6 No |
Post New Answer View All Answers
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
Define conversion efficiency of a power amplifier.
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
what are the principles of a booster converter?
List few applications of d.c series motor?
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
why tertiary winding is used in transformer with diagram?
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.
will there be any problem by recovering slip from single phase induction motors?
Why earthing is necessary for any equipment?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Why does the rotor rotate?
