what is the advantage of NiCd battery over Lead acid battery?
- 2 Answers
- 18720 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / vishnu
NiCd batteries typically last longer, in terms of number
of charge/discharge cycles, than other rechargeable
batteries, and have faster charge and discharge rates than
lead-acid batteries, with minimal loss of capacity even at
high discharge rates.*The most common alternative to NiCd
batteries are '''[[lead-acid battery|lead-acid
batteries]]'''. Compared to these, NiCd batteries have a
much higher [[energy density]]. This means that, for a
given battery capacity, a NiCd battery is smaller and
lighter than a comparable lead-acid battery. In cases
where size and weight are important considerations (for
example, some transportation applications), NiCd batteries
are preferred over the cheaper lead-acid batteries.
| Is This Answer Correct ? | 31 Yes | 6 No |
Post New Answer View All Answers
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
Greeting to all members, How to calculate spill current when we have different ratio CT and Class for REF(Low Imp) I have 500/1A 5P20 @line side n 400/1A CL.X @ Neutral.
What is shutdown of electrical sub station?
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
how we calculate the withstansing current capacity of wires&cables?
How to Preparation of online test
What are dependent sources?
what is magnetizing current test in power transformer
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
Under wat condition statcom operates as an inductor for the transmission line?
