Interested to Buy Any Domain ? << Click Here >> for more details...
question related 2 soal car:
Working under a bright light bulb or in direct sunlight,
experiment with the angle of light hitting the solar
panels. What angle gives you the fastest rotation of the
wheels?
How would you modify this car to make the wheels turn
faster?
How would you modify this design to make a car that could
carry or pull a heavier load?
How could you modify this design so that your car could run
for short periods in complete darkness or low light
situations?
- 1 Answers
- 3697 Views
- I also Faced
- E-Mail Answers
Answer Posted / shafi
The amount of solar energy absorbed from the source will not
depends upon how much brighter the source but depends on the
intensity of radiation of generation and angle of projection
on to the surface of solar panels.
Capability of absorption of radiation depends upon the
length of radius from source to solar surface and would be
maximum at 90 deg angle as reflection from the surface will
be minimum.
I would be know that in a solar car the torque for the
wheel is supplied from an electric motor. The source for the
electric motor is from the batteries which can be charged by
solar energy. wheels can run faster as u give higher voltage
to the motor. So the speed of car depends on your motor
capacity and the distance you could travel depends on your
battery bank charging capacity.
If you increase the capacity of motor you will have
higher speed as well as you can modify the design to make
your car that could carry heavy loads.
By increasing the size of the battery bank (in sens
capacity to store energy will be increased) you can run the
car for short periods in complete darkness or low light
situations.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
sir,iam applied rrb chennai for the post of junier engineer,i need objective type question book,please refer the suitable book,author and publication.
what will happen if petrol engine make to run with diesel
In Turbine how the balence piston works and what is the direction of leak of steam flow.
what's the diffrent between k engine series and qsk engine series and specialey fuel system
what is the difference between En19 and En24
plz send me the aptitude test paper for hpcl.
Explain the formula of heat loss in a pipe.
What are the causes of failure of boiler tubes ?
hello i have a problem !!!! i am studying gait analysis"human walking; and i had only single camera"sony 25 frames/s" and 2 separated force plates, and there is no synchronization between the camera and the force plates!. i wrote a matlab program to calculate joints moment(sagital) using inverse dynamics methode. and there is a problem with the output data!! can you help me.
what is the dome assembly
I need BHEL apptitude questions
define material grades 15b25,10b21,scm-415,16mncr5 in detailwith their compositions
What do you understand by engineering drawing?
thermal engg
explain about where should we use deep groove ball bearings,angular contact ball bearings,spherical roller bearings,taper roller bearings,cylindrical roller bearings and thrust bearings
