Interested to Buy Any Domain ? << Click Here >> for more details...
In a house wiring why we are using only one neutral wire and
so many phase wires from the main board, when the load is
common for both wires?
- 3 Answers
- 16901 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthik raman.b
only one phase we r using in house wiring if u have 3 phase connection u will be have 3 phases.....from main board we r distributing the supply to different areas thats why we have many phase wires
| Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
what is the isolation transformer. what is the isolator?
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
Why 9KV surge arrester having 7.65KV of MCOV?
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
wat is d diffr btw shunt coil and trip coil in VCB?
Initially, when the input is not equal to the output — what type of response is this?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Difference between field rheostat and armature rheostat.
