What are the voltage values for LT,HT,EHT and other
voltages??
Answer Posted / abishek.k
LT is 440V
HT is above 440V
At 11KV HT Line got neutral is called EHT
| Is This Answer Correct ? | 5 Yes | 24 No |
Post New Answer View All Answers
Please give me a erda placement paper
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
induction 3 phase motor terminal connection
what is the difference between oil surge relay and buchholz relay.
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
bsec exam syllabus (mis)
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
Write down the name of 2 lady Bir Pratin of Bangladesh
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
Why field rheostat is kept in minimum position?
Why is the starting current high in dc motor?
What is the percentage loss for aluminium wire for HT line more than 11KVa
Is there chopping current in resistive circuit
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.