Answer Posted / oscar b. ano-os jr.
instrumentation is the science and art of using instruments
in a control system for the purpose of monitoring and
control of the process variables such as flow, temperature,
level, pressure and so forth...
| Is This Answer Correct ? | 36 Yes | 0 No |
Post New Answer View All Answers
What is the use of temperature compensation?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what about your moleg in pogrees with company
What is zero elevation and zero suppression?
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
the output of the common trasmitter protocol in qatar gas are the following
How to Calibrate Level Troll in field
give eg of how I/P is used in control loops
how to commission furnace ( water heater)
it is possible to check the fail safe condition in pressure transmitter. if possible how?
What are the interlocks we have to check during the start up of LP/HP compressor?
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.
