Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manikanta kumar gopi
I think 230V DC supply is large as compare with 230V A.C.If
we use same rating there is damage to the appliances.(which
is specially inicating the rating on the appliances)
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
please give me solution to rectify the emi(electromagnetic interference)
How to perform a DC resistance test In Alternator and their proceduces?
What is MS-EXCELL?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
how works inductive &capacitive sensors?
Electronic circuit
at what base you will tell the direction of rotation of dc motors and generators?
What is the complete procedure of erection of electrical panel in industry
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
how to calculate the change over time for star delta starter for different KW motor?
Why is better to have a minimum ceiling voltage of 250% than 160%?
What are the characteristics of negative feedback?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
