Interested to Buy Any Domain ? << Click Here >> for more details...
Why the Proximitor supply should be Negative voltage? Why
should not we give Positive voltage to the Transducer?
- 6 Answers
- 16325 Views
- Moser Baer, I also Faced
- E-Mail Answers
Answer Posted / maya ramesh
Proximity or vibration measurement circuits use NPN
transistors andNPN transistors are -ve voltage based
devices and have particular advantages and the whole old
lot of proximity measurement circuits are being driven by
NPN transistors.
| Is This Answer Correct ? | 24 Yes | 2 No |
Post New Answer View All Answers
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
please tel me the calibration of pneumatic controler.
How hart protocol can be connected with control valves?
Valve positioner and actuators in detail.
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
the output of the common trasmitter protocol in qatar gas are the following
why we are not using the turbine flow meter in the steam service?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
what diffrence b/w plc s7200,300,400
