Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT HAPPEN WHEN CT SECONDARY OPEN DURING LOAD
- 16 Answers
- 32222 Views
- Neco, I also Faced
- E-Mail Answers
Answer Posted / rasaannamalai e
According to the Transformer theory..The formule is
E1/E2=N1/N2=I2/I1=K..In CT Primary Turns is Only one ie.Bus
bar.But the secondary turns is more depends upon the ratio
which we choose..From that we can say it is stepup
transformer when it is in opened secondary...
for example 1000/1A ,415v what will be the secondary
volage in Opend secondary CT.
Let's see
I1=1000A,I2=1A,E1=415,N1=1turn,N2=? and E2=?
1/1000=415/E2
E2=415*1000
E2=415kv....This much voltage get induced in CT
secondary due to Induced emf.
And,
E1/E2=N1/N2
415/415k=1/N2
N2=415k/415
N2=1000Turns.
From the above answer we can say CT is Stepup
Transformer..If it gets open during load condition it get
saturate or Blast because of very high heat and less
Iinsulation.
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What are the advantages and disadvantages of closed-loop control system?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
What is the operating principle of turbo-generator.
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
how can we make cable shedule for controll wiring ? which details must be required for it.?
Why Neutral Isolation is required?
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
How to calculate the Harmonics losses in terms of cost/unit.
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
List examples of voltage source?
what is the calculation formula for motor starting torque,running torque, running torque.
distribution transformer de-rating formula on over limit iron losses
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
Which is the largest hydropower station in the world?
