Interested to Buy Any Domain ? << Click Here >> for more details...
when ur using single phase type of load for a 3.5core power
cable .Why neutral is .5 and how much current in the
neutral if we consider neutral as a reverse path for three
phases.
- 2 Answers
- 5631 Views
- I also Faced
- E-Mail Answers
Answer Posted / kishan
If the current in all three phases are equal,the current in
the neutral is zero,hence the neutral conductor is half the
size of Phase cable.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
State norton’s theorem?
what is your aim
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
In synchronization circuit what is the function of Interposing voltage transformer(IVT)and Reverse voltage transformer(RVT)
What does the term supermesh means?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Differentiate between low pass, high pass and band pass filter?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
Why can't we parallel Voltage transformer secondary circuits?
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
main difference between ac and dc?
