defffrence between instruments and instrumentation
- 8 Answers
- 31466 Views
- I also Faced
- E-Mail Answers
Answer Posted / maddy
Instruments means all the field instruments which we are
using for sensing the process parameters & instrumentation
means collecting all the data from that instruments & then
used for Automation.
| Is This Answer Correct ? | 33 Yes | 6 No |
Post New Answer View All Answers
what is scale factor of proximitor & unit of the vibration.
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
Questions on flow meters,few questions on HART protocol,
why we are not using the turbine flow meter in the steam service?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
Difference between dcs and plc including date processing and architecture.
what is isloted barrier how it works and what are the main purpose.how it make safe area.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
What is the start up procedure of desalter
What are different types of valves?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
what diffrence b/w plc s7200,300,400
