Interested to Buy Any Domain ? << Click Here >> for more details...
which is more effective , a single extraction with a large
volume of solvent or several small volume extractions?
Explain.
- 2 Answers
- 7179 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohan
several small volume exractions are quiet best than the
single exraction..coz thr may be a chance for getting the
undesired product,i mean we dnt get the desired
quality..and also the feed must not be fully extracted in
case of single exraction,moreover it takes much time to
extract the feed..but in multi extractions with small
volume fullfill the drawback from the single extraction..it
takes less time to extract the feed..
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Explain the process of including heat exchangers in ammonia refrigeration system?
What is load?
What are the customization steps in sap?
What is critical radius of insulation?
How can one estimate how the friction factor changes in heat exchanger tubes with a change in temperature?
What are advantages using hollow shaft impeller?
We are having proplem with the persperation smell in ETT/ECHO room in our cardiac hospital.The 2 Ton of AC is not conditioning the environment. We have to use exhaust fan to through out of the room bad air. Could anyone suggest how to coup with this effectively using chemical engineering. Any permanent solution to neutralise the bad smell.The Air freshners are not doing enough instead making a bad odour.
For amonia manufacturing process if pressure, temperature would be increase over optimum level what would be happen?And what steps should be taken?
What type of flow measurement devices is best for slurries?
How is plate heat exchangers used in an ammonia refrigeration system?
What is the best way to configure a bypass line in slurry services?
what is the cast iron grade of composition of c-3.06% , Mn- 0.48% , Si-2.38% , S-0.088% , P-0.092% , Cr-0.12% , Ni- 0.012% , Mo-0.00%
How can I treat a waste stream containing both hexavalent chromium and arsenic?
What is the best way to handle bend or turns in slurry piping systems?
Define viscosity?
