What is the major difference between cnc and plc. why cant
we use plc instead of cnc
- 5 Answers
- 36669 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin kashid
PLC Is Programmable Logic Controller
CNC IS Computerized Numerical control.
But There is major difference is in Execution of program
CNC Is Conditional and PLC is Sequential
| Is This Answer Correct ? | 32 Yes | 13 No |
Post New Answer View All Answers
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
aternator every parts and its working
working of diesel generator ?
why should the primary of transformer be connected in delta in a heat run test?
How to Calculate KA Rating of Main LT Panel
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
What is slope...? Explain slope 1 and slope 2...?
Define rise time.
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
what is the function and use of cable differential protection relay?
Is a d.c.compound motor is use as a booster? how?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
