Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sudheer
suppose one 11KV DG is running, when we start the DG it
will make only 600 to 700v only, because that time the AVR
is not connected in the circuit, when we switch on the
AVR , the AVR gives the supply to exciter assyembly and the
rotor of alternator gets more exciting current and this
rotor current cuts more flux and the main voltage
increases , when it reaches to 11000v , the AVR sense the
11 kv and it minimised the supply voltage to exciter.
so we can say that when AVR fails, the generator will not
make voltage .
| Is This Answer Correct ? | 15 Yes | 5 No |
Post New Answer View All Answers
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
What is the operating principle of turbo-generator.
In CTs tan delta point should be earthed , what is the reason behind it?
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
electrical knowelge
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
why we used dc supply for field in dg set
What does quality factor depend on in resonance?
What is the dependency of stiffness on load angle??
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
Alternator rotor earth fault relay circuit
how to check regenerative load in drived motor
