Interested to Buy Any Domain ? << Click Here >> for more details...
what is the differents and advantages of Electro magnetics
relay and static relay ? what is the numerical relay ?
advatages?......
- 7 Answers
- 23756 Views
- CAT, L&T, TCS, I also Faced
- E-Mail Answers
Answer Posted / pramod kumar
Electro magnetic relays r 1st generation relays they use
principle of elecro magnetic principle.they depend apon
gravitation also and the value changes to the surrounding
magnetic fields also.
static relays r 2nd generation relays.In this relays
transistors and IC's r been used. there value may vary wrt
temperature also.
numerical relays are present generation relays. They use
Microprocessor. with in built software and predefined values
if any values extend the predefined values then relay gets on.
by this relay we can find distance of fault also.
| Is This Answer Correct ? | 24 Yes | 2 No |
Post New Answer View All Answers
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
what is POTT and PUTT explain?
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
What is superposition theorem?
why transmission is only 3 phase and not 2 or 4 or poly phases
Fantio of tranformer
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
What is the main purpose of c.f.b.c.boiler
What are the limitations of Kirchoff's laws?
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
block diagram of 2 ups system connected in parallel mode?
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
how to find the Motor,s insulation Power?
