is it possible to step down voltage of single phase from a
three phase sysem? explain
Answer Posted / y.vidya sagar
Yes, we can use autotransformer connection or tappings on
one phase to get the reduced voltage in one particular
phase while all the other phases give the same magnitude of
voltage as before to the load. As the tapping is varied we
can get the variable voltage.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is open loop and control loop systems?
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
What are the advantages and disadvantages of negative feed back?
what type of motor used to move a 1 ton gate? and relate ratings with load.
Why 11kv to be generated in generation station
in non technical way how can u define POWER FACTOR??
what you have to see after one week or month from the day of installation of transformer ?
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
Single line diagrams for star to delta and DOL starters.
Mention how NPN and PNP transistor works?
What is the settings of distance protection relay in 400 kv line
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Pleae send me last 5 years of Question book about RRB chennai.
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME