Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shyam majgaonkar
The power consumed by the resistive element of the circuit
with Impedance is termed as Active Power
P= V*I*p.f.
P=I*Z*I*(R/Z)
P=square(I)*R in Wattd
The power consumed by the Impedance of the circuit is
called as Active Power
S=V*I
S=I*Z*I
S=square(I)* Z expressed in VA
| Is This Answer Correct ? | 8 Yes | 32 No |
Post New Answer View All Answers
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
How many gap between finger contact in a.c.b. and v.cb.?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
how to compute kvar in substation feeder to improve power factor and sending voltage
what is the importance of Partial Dischage test for Electrical Equipments
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
What is the unit of magnetic flux density?
Difference between low impedance and high impedance Restricted Earth Fault
Why line VTG = √3 phase VTG in star? How?
What are the function of different components of servo motor?
Pl.brief me any electrical major fault you have rectified.
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
My question is abt backlog.I had dropped one subject in my second year, and completed this subject in the 3rd attempt, so how many backlogs i have got?1 or 3?plz sujjest the answer as soon as possible
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
