Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using R,Y,B colours for 3 Phase ?
- 4 Answers
- 10454 Views
- ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / vishwa
Because they are primary colors
RED, YELLOW, and BLUE
| Is This Answer Correct ? | 18 Yes | 21 No |
Post New Answer View All Answers
What is lifting power for 1 wb/m2 and 1 A magnet?
what is differnce btwen lll and lllg faults
Instrument connected to a single phase supply
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
What is grid collapse? what is the reason for it?
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
Why the output of OP-AMP is always less than Vcc?
hello friends..... any one have papers or any study materials?sail ,hpcl...?
what is the difference between 2 way and 4 pole selector switch???
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
can i use the six sigma method which is used in management area, in state estimation of power systems?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
