can any one help me?
1.what is corona extinction voltage&corona inception
volatage
2.what is mean by CFVV?
Answer Posted / yasser
Corona Inception
Corona inception voltage is the lowest voltage at which
continuous corona of specified
pulse amplitude occurs as the applied voltage is gradually
increased. Corona inception
voltage decreases as the frequency of the applied voltage
increases.
Corona can occur in applications as low as 300V.
Corona Extinction
Corona extinction voltage is the highest voltage at which
continuous corona of specified
pulse amplitude no longer occurs as the applied voltage is
gradually decreased from above
the corona inception value. Thus, once corona starts, the
voltage must be decreased to get
it to stop.
CFVV - constant flux voltage variation
The short notation of tapping range and tapping steps
indicates the variation range of the
ratio of the transformer. But the assigned values of tapping
quantities are not fully defined by
this alone. Additional information is necessary. This can be
given either in tabular form with
tapping power, tapping voltage and tapping current for each
tapping, or as text, indicating
'category of voltage variation' and possible limitations of
the range within which the tappings
are 'full-power tappings'.
Thus CFVV is defined as the tapping voltage in any untapped
winding is constant from tapping to tapping. The tapping
voltages in the tapped winding are proportional to the
tapping factors.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
What is the type of feedback used in an op- amp schmitt trigger?
how the aircraft outer body and inner body is separated ?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
What are motor generator sets and explain the different ways the motor generator set can be used ?
How stabilizer works??
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
how to calculate energy of 3-phase motor?
What is Tachometer used to measure?
What is the function of under voltage release ?
why we not used 11kva as a direct our electrnics component.
Why is better to have a minimum ceiling voltage of 250% than 160%?
why do we have spikes enough to burn electronic boards, when generators are not grounded
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act