for 500mw power production how many range of transformer
set in unit please reply if three transformer use .
Answer Posted / umar
Taking power factor = 0.8
so MVA rating for 1 transformer will be =500 / 0.8 = 625 MVA
if three no. of transformers are used then rating of each
transformer will be 208 MVA.
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
please explain to me how to calculate current,voltage,resistance with formula??
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
what is PWM in IGBT and how it works for drive.?
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
orifice sizing how done, checking & selection
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
can we do the star delta connection of capacitor for 3- phase motor starter.
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
what is active power & reactive power?
explain remenance . differentiate high remenance type ct & low remenance type ct
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV