Answer Posted / vivek

opamp gain is is very high about greater than 1000
so according to formula gain A=Vo/Vi, Vo=A*Vi, Vo=1000*Vi,
so if we apply small voltage of .025V, we get o/p volatage
Vo=1000*.025=25V, so due to high gain we need very small
or negligible amount of i/p voltage or current. so we
ground the one port at i/p side it means no current flows
through it but practically it always has some value in the
fraction of ampere.

what is difference between hybrid model and h parameter model and what is technical use of h parameter model

3906

---

What are the main purposes for which a common-collector amplifier may be used?

1149

---

what is the value of TEI ist T1?

1912

---

In a 2 stage RC coupled amplifier, the emitter resistance of 1st stage consists of 2 resistances (Re and Re')in series and the bypass capacitor is connected across only one of them(bigger resistance). Why?

2809

---

What is meant by operating point?

973

---

what is receiver device in ir receiver which catch over signal of ir?

2043

---

What is a zener diode?

1050

---

How an ammeter can be changed to a voltmeter?

1118

---

What is the use of all pass filter?

994

---

What is the forbidden energy gap? How does it occur? Define what is its magnitude for ge and si?

1252

---

how can i get old question papers and solved problems of vtu university karnataka...... if u know plz do reply

3277

---

Can a gas be used for conducting current?

1024

---

The electric field in the space charge region decreases with forward bias and increases with reverse bias. Why?

1026

---

can a machine with a single DNS name have multiple IP address?how could this occur.

2144

---

What are the two modes of mosfet?

1103

---