Interested to Buy Any Domain ? << Click Here >> for more details...
how the 12 pulse rectifier is made?
- 8 Answers
- 19363 Views
- Engineers India Limited, I also Faced
- E-Mail Answers
Answer Posted / venu
Is it possible to obtain more pulses than twice the number
of phases in a rectifier circuit? The answer to this
question is yes: especially in polyphase circuits. Through
the creative use of transformers, sets of full-wave
rectifiers may be paralleled in such a way that more than
six pulses of DC are produced for three phases of AC. A 30o
phase shift is introduced from primary to secondary of a
three-phase transformer when the winding configurations are
not of the same type. In other words, a transformer
connected either Y-Δ or Δ-Y will exhibit this 30o phase
shift, while a transformer connected Y-Y or Δ-Δ will not.
This phenomenon may be exploited by having one transformer
connected Y-Y feed a bridge rectifier, and have another
transformer connected Y-Δ feed a second bridge rectifier,
then parallel the DC outputs of both rectifiers. (Figure
below) Since the ripple voltage waveforms of the two
rectifiers' outputs are phase-shifted 30o from one another,
their superposition results in less ripple than either
rectifier output considered separately: 12 pulses per 360o
instead of just six:
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
what is the IPC ? & what the uses ?
What is CCM in Electrical ? where can we use this material?
in non technical way how can u define POWER FACTOR??
What are the different towers used in 132kv transmission line? what are the differences between the P,R,S towers used in 132KV and detailed explanation
what is the prosses for getting of 33kv licence (i have completed my engineering degree & working in 33kv substation for contract basis )????
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
what is the carona effects meaning in HT line transmmission system
Direction of flow of active power and reactive power with logic?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
The simple way of finding the leakage quantity and % in compressed air distribution system
At full load wat is the motor p.f And at no load will is the motor p.f?
as a electrical student why should i hire you?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Compare salient pole and cylindrical rotor machines.
What is the type of earth fault protection used in battery? explain.
