Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / budhaa lal the great
for line to line fault open the bus chamber and hold the
two phases with your hand u will get line to line fault and
also feeling of it.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
why we are using earth pit in sub stations.?
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
how to calculation increase power factor for single phase
why the projects getting loss?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
What is servo motor and what are the applications of servo motor?
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
Define phase lag and phase lead?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
