Interested to Buy Any Domain ? << Click Here >> for more details...
flurescent bulb rating is to 230v,50HZ.now flurescent
connected 230v,25HZ.whether nreduced frequency will affect
the glowing properties of flurescent.
- 6 Answers
- 8919 Views
- I also Faced
- E-Mail Answers
Answer Posted / nahin
yes.
fluorescent bulb works under the principle of scattering of
electron.An incident electron collides with an atom in the
gas. According to the Einstein formula: Kmax=hf+phi,
the kinetic energy depends on the frequency. So, if we
reduce the frequency, the kinetic energy of electrons will
also be reduced and thus the performance will be degraded.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Define availability (operational)?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
While testing LA mast,What are the parameter limits ?
how a.c. genarator control power factor when its conected to grid supply by incrising or decresing excitation voltage.
I am inpecting a 10kVA UPS what tests should i do and should i observe?
what is the ms flat constant for calculating earth mat design calculation?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
how to check avr of dg set of 125kva
At full load wat is the motor p.f And at no load will is the motor p.f?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
How do u analyse protection fault when vcb tripping on load
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
What is Antipumping Function & If we have C.T how we find the Ratio ?
