Why all voltage levels are the multiples of 11KV?
Answer Posted / khongserbu
since all the voltage generation are in average and we use
rms quantities for computation. so we need to convert the
average to rms simply by multiplying the form factor 1.11.
thats how the voltage levels are in the multiple of 11.
So stop fighting both of u
Dr. khongserbu
university of lungzor
poktor
Chazzam
Is This Answer Correct ? | 45 Yes | 26 No |
Post New Answer View All Answers
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
why r we using shell transformer for low voltage
What is resonant peak?
what happens when series resonance occurs?
Define phase lag and phase lead?
Transmission through a short line depends on
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What is the formula to find out two phase active & reactive power
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
why sielent pole is used only in hydro generators and not in turbo generators
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?