Can I use measuring current transformers in protection
purposes?
- 7 Answers
- 10616 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohit varshney
Mr. Minu.....
I am working as a commissioning engineer in in switchyard
in 2x600 MW thermal powerplant. i have myself done the ct
commissioning here. if u want i can send u proof of wht i
have answered to this question...so better check ur
credentials and dont mislead ppl.
| Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
how can we design robots
what is the standard duration after failure EB power
What are the differences between single phase and three phase?
What is corkscrew rule?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.
distribution is maximum done by a)radial b)network c) parallel d)b & c
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
Difference between HRG and NGR. Are they both the same thing
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
