why the three phase transformer's star point does not
sparks or seperated? while we often see that two phases
touches each other it sparks and ocationaly conductor
breakes out.
- 4 Answers
- 7085 Views
- I also Faced
- E-Mail Answers
Answer Posted / manojkrishnan
explain which side of the transformer - ( primary or
secondary )?
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
What is resonant frequency?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
why the rotor current becomes in steady state during high slip region? please verify with equations.
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
What happens if we connect a single phase energy meter in reverse polarity.
what is the saturation point of crgo lamination.
Define pole pitch?
What is the difference between isolators and electrical circuit breakers?
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
List of equipments required foe industrial repair lab.
why we change the direction of winding in rotor ?how we make the north and south pole?
