Answer Posted / devendranchandrasekar
During the time of manufacturing bricks mixture of minerals
like silica, clay,ash,sand,etc this propotionate should
vary in all every production and also watercontent plays
very major role in the bricks
as per IS CODE SAYS 15 TO 20 PERCENT is the max limit of
water absorption brick in 24 hrs
water absorption in bricks depend only voidratio of bricks
and also poor compaction ,
well burnt bricks it should be burnt on all sides equally
good shape also all dimensions should be in proper and
clear
| Is This Answer Correct ? | 31 Yes | 7 No |
Post New Answer View All Answers
In Rcc ratio calculation I wanted to know quantity of Steel also.
how much cement and sand required for 1cum rr masonry
What is the use of offset command?
4. Differentiate between NC and OC soils. Draw curves for (i) Stress vs Strain (ii) Volume charge vs Strain (iii) Pore pressure vs Strain for these soils
What are wooden shingles?
What is Heavy Concrete & Normal Concrete
What is difference between code and standard and specification?
In tower foundation, on the time of 3 mtr pit RCC casting if water and mud is their surface of PCC then what will be do?
how to caluclate sienerge qty in construction in ap
how to calculate MR 9(derivation)
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
Define What is diversion tunnel in a dam?
Define line type?
in design case of structural member best suitrable percentage of steel limit is what
Test procedure of fly ash bricks as per code ?
