How much voltage we get between two wire of 4 to 20 ma
output? Is this voltage up or down respectvice to 4 - 20
ma ?
- 9 Answers
- 12191 Views
- I also Faced
- E-Mail Answers
Answer Posted / mail2noor.hyd
voltage is 0-10V
transmitter i/p supply (source) -24V
o/p -4-20mA/0-10V
we prefeered always current i.e 4-20mA,
b coz voltage travel a long
distance voltage will drop, so thats y we preffered
current i.e 4-20mA
voltage is 0-10V
from mail2noor.hyd@gmail.com
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
how to work static pressure sensore how to work dpt
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What is furnace draft control?
Calibration procedure for water rotameters
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.
what is diffrance between FF & SMART, explain with difination
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
Operational amplifiers
What are different types of control valves?
Q- What are the application in which PNP transistor is preferred over NPN ?
