is it possible to step down voltage of single phase from a
three phase sysem? explain
Answer Posted / aamod tripathi
YES BY USING A SINGLE PHASE TRANSFORMER
Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
How to check the cable fault / hv test of transformer cable.
difference between semiconductor & conductor & insulator?
how to decide the capacity of accl
What is Plank's Law?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
What is different between resistance grounding system and resistance earthing system?
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
Dear all i am kumaravel. now in chennai. my work is control and relay panel auto cad designing.up to 11kv to 400kv then question is i am improving my knowledge. i want some books name and auther are available for this C&R panel related. plese any one help me
Any one can explaination about calibration with rotating sub standards?
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
what is arc flash and what are the hazards involved
why on delay timer used for fully automatic star delta starter?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Electrical Engineering