Answer Posted / mallikarjuna reddy
it is the ratio of realpower and apparentpower.
and it can also defined as the angle between voltage and
current.
Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
is all the servo motors having brake?please specify which servo motors having brake for stop on position and which are not.
state the working principle of incondenscent tube?
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
Explain dc generator with its types?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
What are the various types of BUSBAR Schemes? explain each
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
what is the difference between directional & non directional earth fault with example please explain.
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
Is Transol transformer oil comparable to nynas nytro libra?
Why saturation region slowly shifted in the left side?
What is meant by bus bar protection?