WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT
THE TEMP ARE 0,30,250,320
- 13 Answers
- 22915 Views
- I also Faced
- E-Mail Answers
Answer Posted / khalid javed
it will give the atmospheric temperature.and temperature
will 30
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
Questions on flow meters,few questions on HART protocol,
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
send me last 5 years questions asked in rrb chennai, for section engineer
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
